I. Daily Cleaning and Inspection
Clean the machine body and circuitry: Regularly open the back cover with a screwdriver to clean dust generated by static friction of the motor, preventing short circuits on the circuit board.
Inspect transmission components: Lubricate the bearing housings monthly to ensure adequate lubrication.
Clean the grating and printhead: Wipe the grating with a white cloth dampened with alcohol to prevent dust from affecting the movement of the ink carriage; regularly inspect the printhead to prevent clogging.
II. Lubrication and Component Maintenance
Regular lubrication: Add grease to gear meshing points, guide rails, and other transmission parts to reduce wear and noise.
Inspect vulnerable parts:
Bearing roller: Inspect the rubber bearing roller for aging or pitting; repair or replace if necessary.
Printing roller bearing: If the bearing overheats, stop the machine immediately, replace it, and add grease.
Filter and ink cartridge: Regularly inspect and clean or replace clogged filters; check if the ink cartridge is loose.
III. Safe Operation and Standards
Comply with Operating Procedures: Before operating the machine, adjust the foot pedal to the lowest position and wait until the pedal is stationary before getting on or off the equipment. Never operate facing backward or look back.
Prohibited Improper Operation:
Do not use harsh cleaning agents, paper towels, or rough cloths to wipe the equipment. Avoid touching the control panel with long fingernails.
Do not block the equipment's ventilation openings. Do not stand on the plastic casing or crossbeams.
Do not operate the equipment without ensuring its balance. When moving equipment, lift it, do not drag it.
Emergency Handling: Design a clear emergency procedure, including alarm procedures, evacuation instructions, and emergency contact methods, and conduct regular drills.
IV. Troubleshooting
Immediate Stop: If the flower roller bearing is found to be overheating, the bearing roller is severely damaged, or foreign objects are embedded in the flower roller, stop the machine immediately for repair.
Proper Handling: Damaged parts must be replaced by the manufacturer or qualified personnel. After troubleshooting, restart the machine in the correct sequence.

