How to Prevent Process Problems in Rotary Screen Printing Machines?

Jan 19, 2026

Leave a message

I. Process Optimization

1. Pattern Design

For patterns with high matching difficulty (such as three-color overprinting), it is recommended to use discharge printing or resist printing.

When arranging the screens, those with high matching requirements should not be too far apart. Prioritize printing smaller areas first, then larger areas to reduce the impact of fabric shrinkage.

During plate making, avoid misalignment and white spots by using thread separation or line borrowing methods.

2. Nickel Screen Selection

The circumference of the rotary screens for the same pattern should be uniform. When re-circling, pay attention to the diameter at both ends.

When attaching the printing plate, use calipers and a flat plate for strict selection to avoid misalignment.

II. Operating Procedures

1. Plate Adhesive Management

Uneven adhesive application on the adhesive tape guide or poor fabric application ability will affect pattern matching. The condition of the plate adhesive needs to be checked regularly.

If one side is aligned while the other is not, the plate adhesive may have become thinner. Add new adhesive or replace it with thicker adhesive.

2. Pigment Control

An unstable pigment surface can cause pattern misalignment; maintain a moderate pigment level.

High pigment viscosity can cause smudging; reduce viscosity and ensure semi-finished products are dry.

3. Squeegee Maintenance

Scabs or impurities can cause blade lines; select wear-resistant squeegees and properly control the angle and pressure.

Keep the inner wall of the rotary screen smooth to avoid damaging the blades.

III. Equipment Maintenance

1. Guide Belt and Tension

Uneven tension in the fabric feed can cause misalignment; adjust the guide belt tension.

If the guide belt deviates, check the sensitivity of the correction device.

2. Nickel Mesh Recirculation

Regularly recirculate the nickel mesh to ensure consistent diameter at both ends, preventing misalignment due to inconsistent circumference.

What are some maintenance tips for garment printing machines?

Send Inquiry