From the perspective of material boring, infrared Flash Dryer is already one of the more needed Flash Dryer equipment. Flash Dryer equipment used stove gas drying in the 60s to 70s of the last century, to steam heat exchange drying in the 80s, to the hot air conduction drying and microwave and infrared drying in the 90s. The sand Flash Dryer is in principle and The structure has been continuously improved and progressed.
Since the Flash Dryer equipment at this stage uses conduction heating instead of microwave and infrared heating, the drying results will be uneven if the moisture content is different. Therefore, the reasons for the dry and uneven precipitation of the rotary Flash Dryer equipment are mainly as follows: (1) Material moisture is uneven; (2) Flash Dryer's hot air temperature is unstable; (3) Discharge is uneven; (4) Flash Dryer adds less material and the inner drum is not full; (5) Wind pressure and air volume Small or high and low; (6) There are obstructions and dead corners in the tower.
It can be seen from the above analysis that the elements of the boring and uneven precipitation of the rotary Flash Dryer are not individual, but are related to each other in a very complex combination. The combination of different elements has different results, and only refers to one element. It is unrealistic, and the ambition situation is objectively non-existent. Each element has a different effect, but some can be artificially defeated, and some are more necessary.
